Table of Contents
Advertisement
B. Installing Vent Components
After determining which set of starting collars will be used
(top or rear), follow venting instructions accordingly.
Remove the installed rear seal cap from the rear starting
collars by cutting the strap at each end. (See Figure 24)
Remove the insulation inside the 5” collar. (See Figure 24).
Follow the vent configuration tables accordingly.
Remove the 5” diameter disk in the center of the
heat
shield by twisting the disk and breaking it out. This can be
done from inside the firebox or by reaching through the vent.
Models SL-550TRS and SL-750TRS, the disk may be
difficult to twist and break. Remove the exhaust shield
and rear heat shield. Replace the exhaust shield.
Remove the top vent collar seal cap by cutting the strap at
each end. (See Figure 24) . Remove the insulation inside
collars. (See Figure 24). Next remove the glass door.
Remove the 4” diameter disk in the center of the
heat
shield by twisting the disk and breaking it out. This can be
done from inside the firebox or by reaching through the vent.
You have to take the glass off again for positioning the logs
when the unit is finally installed in place and finished
around it. Re-install the glass door. Attach vent system to
the top starting collars.
Venting Out Rear
Venting Out Top
Insert screwdriver
or simlar object
here to remove cap.
28
CUT HERE
Hide quick links:
Advertisement
Table of Contents
