Advertisement
SCREEN SWITCH WHILE TRIGGER INPUT
7
<Trigger input> or <trigger signal> is when a circuit works by a signal, for example
if driver uses right/left turn signal or reverse gear, the monitor shows connected
camera on driving mode.
※ Below example is based on {TRG1 (Left turn signal)=CAM1 / TRG2 (Right turn
signal)=CAM2 / TRG3 (Reverse gear)=CAM3 / TRG4 (Front or something
else)=CAM4 }.
1) If there is a trigger signal input, the connected camera is displayed as full screen
and switches back when the signal switches off.
CAM1
CAM4
Former screen
2) In case of TRG1 (Left turn signal) or TRG2 (Right turn signal), you can choose full
screen or split screen by OSD setting.
※ This function is for showing not only Left(Right) but also rear side at once, regard-
less former screen status. It displays CAM1(2) and CAM3 as split screen while
TRG1(2) signal input.
CAM1
CAM1 TRIGGER SETUP
Press MENU [
] button of
Press DOWN button of monitor
mo-nitor or SETUP button of
or ▼button of remote control
remote control on CAM1 full
on CAM1 full screen to move
screen mode, then OSD menu
[SPLIT SCREEN] and press OK
appears.
button.
CAM2
CAM2 TRIGGER SETUP
Press MENU [
] button of
Press DOWN button of monitor
mo-nitor or SETUP button of
or ▼button of remote control
remote control on CAM2 full
on CAM2 full screen to move
screen mode, then OSD menu
[SPLIT SCREEN] and press OK
appears.
button.
12
CAM2
CAM2 signal input
CAM1
CAM3
FULL SCREEN
SPLIT SCREEN
If there is the left signal input
(TRG1), then CAM1 (Left) in
left side and CAM3 (Rear) in
right side will be shown on the
screen.
CAM3
CAM2
FULL SCREEN
SPLIT SCREEN
If there is the right signal input
(TRG2),then CAM2 (Right) in
right side and CAM3 (Rear) in
left side will be shown on the
screen.
3) When there is the TRG3(Rear light) input, CAM3 will be shown as full screen
and user can also choose 2 split screen.
※ This function is available for rear and side screen.
CAM1
CAM3
Press ▼button of remote controll
(or DOWN button of mo-nitor),
then it shows 2 split screen as
right for CAM3 (Rear) and left
for CAM1.
When a reverse gear input, the
CAM3
screen displays CAM3 (Rear) as
full screen.
Press ▲button of remote control
(or UP button of monitor), then
it shows 2 split screen as left
for CAM3 (Rear) and right for
CAM2.
4) In case of hazard flasher (TRG1+TRG2), the monitor displays CAM1~CAM4 as
quad split screen. And the screen switches back when the signal switches off.
CAM1
CAM4
CAM1
CAM3
2 split screen using
CAM3
CAM2
CAM2
CAM4
In case of hazard flasher,
4 split screen display
13
Advertisement
