Attaching The Belt Clip; Charging The Battery - Gigaset S820 User Manual

Getting started
To reopen the battery cover to replace
the battery:
¤
Insert your fingernail into the notch on
the top of the cover and push down-
wards. 


Attaching the belt clip

The handset has notches on each side to attach the belt clip.
u
To attach – press the belt clip onto the back of the
handset so that the protrusions on the belt clip
engage with the notches.
u
To remove – press the centre of the belt clip firmly
with your right thumb, push the fingernail of your left
index finger up between the clip and the housing, and
pull the clip in an upward direction.

Charging the battery

The battery is supplied with a partial charge. The batteries are fully charged when the lightning
icon on the display goes out.
¤
Place the handset into the base for 9.5 hours or into the charger for 14.5 hours.
Please note
u
The handset may only be placed in the designated base or charger.
u
Handsets contained in the package have already been registered to the base. If, however,
a handset has not been registered (display "Handset not registered to any base"), please
register it manually (
u
The battery may heat up during charging. This is not dangerous.
u
After a time, the charge capacity of the battery will decrease for technical reasons.
8
9.5 h
or
¢
page 35).
14.5 h