Wireless Communication Using A Static Ip Address - AMX NXT-CV17 Operation/Reference Manual

Configuring Communication
The information can be found in either the Workspace - System name > Define
Device section of your code (that defines the properties for your panel), or in the
Device Addressing/Network Addresses section of the Tools > NetLinx Diagnostics
dialog.
6.
Setup the security and communication parameters between the wireless card and the target WAP by
configuring the Wireless Settings section on this page. Refer to the Step 2: Configuring the Card's
Wireless Settings section on page 55 for detailed procedures to setup either a secure or insecure
connection.

Wireless communication using a Static IP Address

1.
Select Protected Setup > Secondary Connection (located on the lower-left) to open the Secondary
Connection page. Wireless communication is set within the IP Settings section of this page (FIG. 53).
Check with your System Administrator for a pre-reserved Static IP Address assigned
to the panel. This address must be obtained before Static assignment of the panel
continues.
2.
Toggle the DHCP/Static field (from the IP Settings section) until the choice cycles to Static. The IP
Address, Subnet Mask, and Gateway fields then become user-editable (red).
3.
Press the IP Address field to open a Keyboard and enter the Static IP Address (provided by your System
Administrator).
4.
Press Done after you are finished entering the IP information.
5.
Repeat the same process for the Subnet Mask and Gateway fields.
6.
Press the optional Host Name field to open the Keyboard and enter the Host Name information.
7.
Press Done after you are finished assigning the alpha-numeric string of the host name.
8.
Press the Primary DNS field to open a Keyboard, enter the Primary DNS Address (provided by your
System Administrator) and press Done when compete. Repeat this process for the Secondary DNS field.
9.
Press the Domain field to open a Keyboard, enter the resolvable domain Address (this is provided by your
System Administrator and equates to a unique Internet name for the panel), and press Done when
complete.
10.
Setup the security and communication parameters between the wireless card and the target WAP by
configuring the Wireless Settings section on this page. Refer to the following section for detailed
procedures to setup either a secure or insecure connection.
54 CV17 17" Modero Coor Video Touch Panels