Yeti Cycles ASRC 08 Owner's Manual page 9

Line Setup
The AS-R has full cable housing. By using full cable housing, we have eliminated break points in the line
of your shifter housing. This allows riders to experience better overall shifting performance by reducing
the entrance of unwanted elements such as sweat and sediment. Use of full cable housing helps prevent
corrosion from the elements and keeps the shifting smoother for a longer period of time.
Caution:
The failure to properly route shifter housing can cause malfunction of the shift mechanism and unexpected
shifting of gears.
rear Derailleur Fit a piece of housing from the rear shifter across
1
the head tube into the cable stop on non-drive side of the top tube.
Take another piece of housing and secure it in the second stop on the non-
drive side of the top tube. Run the housing over the shock in to the stop on
the seatstay. Make sure there is enough housing so it does not bind on the
shock body.
The last piece of housing is run from the second stop on the seatstay into
the derailleur.
frOnt Derailleur Fit a piece of housing from the front shifter
2
across the head tube into the first cable stop on drive side of the down
tube. Run exposed cable down the down tube to cable guide on the bottom
bracket shell.
rear brake Run the brake line across the head tube to the first
3
open cable stop on the non-drive side of the top tube.
Run the line down along the shock body and into the first open cable stop
on the seatstay. Continue down into the second stop on the seatstay and
attach the line to the caliper.
tip: Use zip ties or cable clips to mount brake line to open cable stops
along bike,
setup HOUSING 18
hOusinG enD Caps Yeti recommends using metal end caps
to maintain the integrity of the housing. The metal caps do not
allow the cable to pull through as do the plastic versions. Do
not mix up the shift and brake housing because it will result
in a loss in performance.