Working With The 70012 Catenary Installation Jig - marklin H0-Oberleitung User Manual

4. Information about Installation

4.2 Working with the 70012 Catenary Installation Jig

The side offset of the catenary wire is checked with the 70012 catenary wire
installation jig. At the same time you can check whether any parts on the
pantographs can hang up on the hanger arms or the catenary wires. The
70012 catenary wire installation jig contains a total of 5 basic jigs, which you
use to determine the appropriate spacing on your track system.
Step 1:
Cut the installation jig for
the desired track system.
Marking for the individual
track systems
Marking for the maximum
side deviation of the cate-
nary wire
30
Step 2:
Set the installation jig on the track under the catenary wire. The catenary wire
must be positioned all over the layout so that it falls within the two limit marks.