Information; Factory Reset - Roberts Stream217 Instruction Manual

Information

Factory reset

If you wish to completely reset your radio to its initial state this may be performed
by following this procedure. By performing a factory reset, all user entered settings
will be erased.
1. Access the menu for the current mode by pressing the Menu button. Rotate the
Tuning/Select control to highlight the 'Main menu' option, then press the control
to select.
2. Rotate the Tuning/Select control until 'System settings' is highlighted and then
press the control to select.
3. Rotate the Tuning/Select control until 'Factory Reset' is highlighted and then press
the control. Rotate the Tuning/Select control and highlight 'YES' to proceed.
If you do not wish to carry out a system reset, highlight 'NO' and then press the
control. The display will revert to the previous menu.
4. With 'YES' highlighted, press the Tuning/Select control. A full reset will be
performed and the radio will restart as if fi rst plugged in. The DAB stations
list together with any preset stations will be erased and your wireless network
connection details will be lost. All confi guration settings will be restored to their
defaults, the clock and alarms will be reset.
In case of malfunction for any reason, reset the product as described above to resume normal operation. It
may be necessary in some cases to disconnect the mains power or batteries, then reconnect power after
10 seconds.
In case of malfunction due to electrical fast transient (burst), reset the product as above (reconnection of the
power source may be required) to resume normal operation.
When connecting the radio to a router with an Ethernet cable, shielded cable is highly recommended. The
communication could be interrupted temporarily or noise may occur if using un-shielded cable and under
strong local interference. Normal communication will resume automatically when the interference signal is
removed. FM radio reception may also benefi t from the use of a shielded cable.
87
Main menu
DAB
FM
Aux In
Sleep
Alarms
System settings
1
System settings
Equaliser
Network
Time/Date
Brightness
Language
Factory Reset
1-4
Factory reset
Proceed?