Electrical Connections; Volumetric Ultrasonic Sensor (If Applicable); Glass Break Sensor (If Applicable); Bonnet Switch - Cobra GLOBE 3800 Installation Manual

Volumetric ultrasonic sensor (if applicable)

Fit the transducers at the top of the 'A' pillars each side of the windscreen, taking care that they
are not covered when the sunvisors are down. If the car is equipped with sliding sunroof, do not
fit the transducers on the dashboard. Check the right position of the transucers during the functional
test of the system. No adjustment is required for the volumetric ultrasonic sensors.

Glass break sensor (if applicable)

Fit the microphone in a central position in the passenger compartment. Eg. in the dashboard,
pointing towards the rear window. This position achieves uniform sensitivity. The sensor can be
used in conjunction with the ultrasonic volumetric sensor. Drawings in the central part of this
manual shows different connection methods.

Bonnet switch

The bonnet switch must be installed to facilitate programming of the alarm and of the central door
locking and turn indicators pulses. Check that the switch is depressed by at least 5 mm when the
bonnet is closed. Ensure that the switch is not acting against sound proofing as these materials
could deform over time.
Control panel
Install on the dashboard in an accessable position. The LED should be visable from outside the
vehicle. In addition to its deterrent function, the panel (LED + push button) is used for programming
and for emergency override.

ELECTRICAL CONNECTIONS

Refer to the enclosed wiring diagrams, and take note of the following:
• route the alarm wires along side the original vehicle harness.
• the system ground must be connected to an original vehicle ground point.
• connect the alarm unit negative and positive feed before reconnecting the car battery.
• the positive supply to the system, must be protected by an adequate fuse located close to the
point of connection (see main diagram).

PROGRAMMING THE SYSTEM

Many functions of this alarm are programmable.
The programmable functions are divided in the following tables: buzzer, basic functions, advanced
functions and sirens. Refer to the user manual for their working description.
Access the programming mode and Self-learning function for the arming/
disarming control signals
It is essential to comply with the following conditions to self-learn the arming/disarming control
signals by means of the vehicle's ORIGINAL RADIO CONTROL:
30 19
INSTALLATION MANUAL GLOBE 3800 GLOBE 3800 MANUEL D'INSTALLATION
06DE2086A.pmd 19 17/01/2005, 14.30