Advertisement
Quick Start
Insert the source and target drives and power up the unit. By default, the
duplicator will initialize, scan for drives, and offer the copy function. When the
copy function appears, press ENT to begin copying.
Canceling Functions
When selecting menu options, canceling is done by pressing ESC. When the
unit is busy performing an operation such as copy, verify, or overwrite, the
operation can be canceled by holding the ESC button until the unit beeps.
Duplicator Functions
The duplicator has three menu sections: The Main menu, Setup Options, and
Advanced Setup Options. Setup Options is accessed through the Main
menu. Advanced Setup Options is accessed by holding the ESC button from
any other menu until the unit beeps.
1. Copy HDD
Scans the ports, then copies from the source to the target.
2. Compare HDD
Scans the ports, then target will be compared to source.
3. PreScan Source
Reads all blocks on the source drive to confirm no I/O errors are
encountered.
4. ReScan BUS
Manually scans all ports and reports how many units were found.
5. Source Size
Examines the source drive and reports total space and space used, if
drive contains compatible partitions. Press up/down to change display,
ESC to exit.
6. Secure Erase
Scans all ports, then erases all data on all connected drives (including
Source HDD). NOTE: some drives will remain in a locked state when the
process is complete. Drives that are locked may not appear to an operating
system and will cause an I/O error if used as a target in the duplicator. If this
happens, start secure erase again and hold ESC to cancel the operation a
few moments after it begins.
7. Overwrite
Overwrite is used to write data onto the entire hard disk, it will destroy all
www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/
Advertisement
