Install The Hardware; Prepare For Installation - Axis Q6032-E PTZ Installation Manual

AXIS Q6032-E/Q6034-E/Q6035-E Installation Guide

Install the hardware

Prepare for installation

Read all the instructions before preparing to install the network camera since several installation
preparation steps require removing the dome ring and the dome cover and would benefit from
being completed together.
• The network camera is supplied with an optional sunshield. If required, follow the instruc-
Attach the sunshield (optional)
tions
• The network camera is supplied with a clear transparent cover. If required, follow the
Replace the clear/smoked dome cover (optional)
instructions
cover.
• A standard or high capacity SD card (not included) is required to store images locally in the
network camera. Follow the instructions
dome cover and install an SD card.
Attach the sunshield (optional)
1. Slide the sunshield over the unit holders on the dome camera unit.
2. Secure the sunshield using the supplied screws (Torx T20).
Replace the clear/smoked dome cover (optional)
!
IMPORTANT!
This camera has a dehumidifying membrane to maintain low humidity levels inside the dome. To
avoid condensation, do not disassemble the camera in rain or in damp conditions.
1. Loosen the 4 dome ring screws and remove the dome ring and dome cover, see illustration on
page 6.
2. Remove the 4 metal ring screws, see illustration on page 6.
3. Remove the metal ring and dome ring from the plastic dome cover.
4. Remove the rubber gasket from the dome cover and attach it to the selected dome cover. Be
sure to attach the gasket so it fits the dome cover perfectly.
5. Align the bulge on the dome cover with one of the logotypes on the dome ring.
6. Attach the metal ring and secure by tightening the 4 screws to the maximum stop.
7. If installing an SD card, refer to the instructions
, below to attach the sunshield.
Install an SD card (optional)
Install an SD card (optional)
, below to replace the dome
, below to remove the
, below.
Page 7