Universal Serial Bus Connectors - DFI BL630-DR User Manual

2
Hardware Installation

Universal Serial Bus Connectors

USB 9
USB 6
The system board supports 12 USB 2.0/1.1 ports. USB allows data
exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The 6 onboard USB 2.0/1.1 ports (Black) are at locations CN8
(USB 0/3), CN7 (USB 6/9) and CN11 (USB 10/11).
The J13 (USB 7-8), J14 (USB 1-2) and J15 (USB 4-5) connectors al-
low you to connect 6 additional USB 2.0/1.1 ports. The USB ports
may be mounted on a card-edge bracket. Install the card-edge
bracket to an available slot at the rear of the system chassis then
insert the connector that is attached to the USB port cables to J13,
J14 or J15.
BIOS Setting
Configure the onboard USB in the Integrated Peripherals submenu
("USB Device Setting" section) of the BIOS. Refer to chapter 3 for
more information.
34
USB 3

USB 0

USB 11
USB 10
USB 1-2
USB 7-8
USB 4-5
9 1
10
2