7
Remove used probe cover
Ejector button
To achieve accurate measurements, use a new, clean probe cover for
each measurement.
To take another measurement, place a new, clean probe cover on the
thermometer. If no action is taken the thermometer will enter SLEEP
mode after 10 seconds or upon return to the thermometer cradle or
host device.
10. Controls
10.1 Memory
Press the MEMORY button to reveal the last completed temperature.
The temperature will show with a MEM indicator until the MEMORY
button is pushed again, a new probe cover is applied, or the
thermometer enters sleep state. Memory can also be accessed from
the thermometer sleep mode and will display for 5 seconds before
returning to sleep.
10.2 C/F (Celsius/Fahrenheit)
Once the temperature scale has been set (See 11.1 Default
temperature scale), the alternative scale can be quickly referenced
at any time while a temperature is displayed.
If the temperature scale is set to Celsius, press and release
1
C/F button to view the temperature in Fahrenheit.
If the temperature scale is set to Fahrenheit, press and release
C/F button to view the temperature in Celsius.
Press and release the C/F button again to revert back to
2
default scale.
NOTE: If Temperature Conversion is disabled, refer to the
Service Manual for more information.
by pressing Probe Cover
.
Mem
C / F
Mem
C / F
Mem
C / F
Mem
C / F
13