Mounting Instructions; Tether Installation - Braun ThermoScan PRO 6000 Directions For Use Manual

8.2 Mounting instructions

Mounting hardware not included.
The large cradle (2 box storage) can be mounted as an easily removable wall hanger or a permanent wall
mount. All mounting must be done into a wall stud. To mount the cradle the following items are needed:
• 2 #8 wood or sheet metal, pan head screws, 3.2 cm (1.25") long
• Ruler (or tape measure could be substituted)
• Screwdriver to match drive of screws
1 Remove probe cover box carrier from
the cradle by rotating the probe cover box
carrier forward.
2
Mount to wall:
• Removable wall hanger:
Locate the stud on the wall. Mount the 1st screw
in position 1 and the 2nd screw in position 2a.
• Permanent wall mounting:
Locate the stud on the wall. Mount the 1st screw in position
1 and the 2nd screw in position 2b. Tighten screws.
Note: Permanent mounting is not recommended if using
the charging station to access the security function, other
advanced functions or charge the rechargeable battery.
3
Place probe cover box carrier back in cradle
by lining up the brackets and pushing down.
Note: For a mounting template please reference
the PRO 6000 thermometer CD.

8.3 Tether installation

A kit to tether the thermometer to the cradle is available separately.
Installation instructions are provided with the tethering kit. Contact Welch Allyn for details.
(Large cradle only)
1
2a
2b
10