Table of Contents
Advertisement
Note
For Turbo Timer Mode on manual transmission vehicles fol-
low the directions in the MTS Mode (Manual Transmission
Start) section with the door open and in step 3 send the
Timer Mode command from the remote control.
Remote Start Faults
For user safety, the system must be properly configured or remote start
will not activate. The Remote Start Fault output (
fault tone) may be caused by any of several configuration issues. If the
remote start fails to activate, refer to the following table for the com-
mand type and parking light flashes that will identify the configuration
issue and solution.
Flashes *
Possible Fault
5
Brake ON
6
Hood Open
7
After performing Remote Start
command - MTS not enabled
After performing Timer Start or
Smart Start command
8
Toggle Switch OFF
None
Alarm is Triggered
* Refers to the number of parking light flashes.
© 2016 Directed. All rights reserved.
AUX
LED on and long
Solution
Release Foot Brake
Close Hood
Enable MTS Mode
Check all Solutions
Turn Switch ON
Disarm or Reset Alarm
33
Advertisement
Table of Contents
