Out of Range
Each time a command is performed the Responder LE will expect a
command confirmation from the system. If a command confirmation
is not received the
plays as an alert.
No Remote Output
Occasionally when a command is performed the remote may not
generate a command confirmation output or Out of Range output.
This indicates that the system received the command but it was an
incomplete command (e.g. AUX button pressed too short to activate
the trunk release) or it was an illegal message (e.g. the command was
corrupted due to local RF interference). These are temporal nuances
of the system and remote, perform the command again within 10
seconds to return to normal operation.
Feature not Available
The Feature Not Available output (
generic one which varies in cause and solution depending upon the
command used:
Command
Runtime Reset
Sensor Bypass
Defroster
36
AUX
and transmit LEDs flash and a long fault tone
Cause
Remote Start is OFF
System is not armed
Remote Start is OFF.
Not configured for
this.
AUX
LED on and long fault tone) is a
Reason/Solution
Only available when Remote Start is ON
Only available when system is armed
Only available when Remote Start is ON.
Only available when configured for
Defroster control.
© 2016 Directed. All rights reserved.