Remote Control Command Table; Fault Condition Alerts - Viper 5806V Owner's Manual

Remote Control Command table

Direct Access
Level
Button
Arm/Lock
(Panic)
Disarm/Unlock
Remote Start
A U X
A U X
AUX AUX/Trunk
A U X
A U X
Advance Level,
Change Car
(3 sec.), Enter
programming
(8 sec.)

Fault Condition Alerts

If, when performing a command, a condition exists that does not al-
low activation of an Alarm feature* or Remote Start feature**, a fault
tone plays to alert of the fault condition.
* Alarm feature not available when the system status is incorrect
upon receiving the command. (Example: Sensor bypass com-
mand is received when disarmed).
Refer to the notes included in the following command descriptions
that address these faults or go to Feature not Available under the
"Remote and System Operations" on page 34 for details.
** Remote Start feature not available when the Remote Start status is
incorrect upon receiving the command. (Example: Runtime Reset
command received when remote start is off).
8
A U X
x 1
LEVEL 1
Silent Arm Sensor
Bypass
Silent Disarm Remote Valet
Runtime Timer Start
Reset
AUX 1 AUX 2
Temperature Arm Status
Check (2-way only)
(2-way only)
A U X A U X
x 2
LEVEL 2 LEVEL 3
Sensor Silent
Arm
Car Finder
Smart Start
AUX 3
Runtime
Remaining
(2-way only)
© 2016 Directed. All rights reserved.
A U X
x 3 x 4
LEVEL 4
Full Silent
Arm
Defogger
AUX 4