Initial Set-Up And Operation; Operator's Safety Precautions; Operating Controls And Indicators - Stoelting O411 Operator's Manual

3.1

OPERATOR'S SAFETY PRECAUTIONS

SAFE OPERATION IS NO ACCIDENT; observe these
rules:
A. Know the machine. Read and understand the
Operating Instructions.
B. Notice all warning labels on the machine.
C. Wear proper clothing. Avoid loose fi tting garments,
and remove watches, rings or jewelry that could
cause a serious accident.
D. Maintain a clean work area. Avoid accidents by
cleaning up the area and keeping it clean.
E. Stay alert at all times. Know which switch, push
button or control you are about to use and what
effect it is going to have.
F. Disconnect power for maintenance. Never
attempt to repair or perform maintenance on the
machine until the main electrical power has been
disconnected.
G. Do not operate under unsafe operating conditions.
Never operate the machine if unusual or excessive
noise or vibration occurs.
Cylinder Off/On
Main Freezer
Power Off/On
Cab Off
Indicator Light
SECTION 3

INITIAL SET-UP AND OPERATION

Freezing
Figure 3-1 O411 Controls

3.2 OPERATING CONTROLS AND INDICATORS

Before operating the machine, it is required that the op-
erator know the function of each operating control. Refer
to Figure 3-1 for the location of the operating controls on
the machine. For the information regarding error codes
displayed on the control panel, refer to the troubleshooting
section of this manual.
A. MAIN FREEZER POWER SWITCH
The Main Freezer Power switch is a two position rocker
switch that supplies power to the IntelliTec control, freez-
ing cylinder circuits lower cabinet refrigeration system.
When the switch is placed in the ON position, the cabinet
refrigeration system will run until the preset temperature
is reached; then it will cycle ON and OFF to maintain that
temperature. Power to the freezing cylinders can then be
controlled with the Freezing Cylinder OFF/ON switch.
B. FREEZING CYLINDER OFF/ON SWITCH
The Freezing Cylinder OFF/ON switch is a two position
toggle switch used to supply power to the freezing cylinder
control circuit. When the switch is in the OFF position,
the freezing cylinder's refrigeration system and auger will
not operate. When the switch is in the ON position, the
machine will be operational.
Dispense
Rate Adjustor
7
IntelliTec Control
(See Figure 3-2)
Pump Power
Off/On