Installing Fs700 Series Onto A Carrier Board - DFI Qseven FS700 Series User Manual

Installing FS700 Series onto a Carrier Board

Important:
The carrier board used in this section is for reference purpose only and may not
resemble your carrier board. These illustrations are mainly to guide you on how to
install FS700 Series onto the carrier board of your choice.
1. Note the key on the MXM connector. The key ensures that FS700 module can be plugged into
the connector in one direction only.
MXM connector
Chapter 2 Hardware Installation
Chapter 2
2. Grasping the FS700 module by its edges, align it into the MXM connector at an angle of
approximately 45 degrees. The FS700 module must be installed into the MXM connector on
the carrier board without any gap between the MXM connector and the gold finger.
gold fi nger
FS700
3. Press the FS700 module down and use the 4 mounting screws provided to secure it to the
carrier board in position before you operate the system unit.
17
MXM connector
FS700
mounting screws
FS700
without the gap between the MXM
connector and the gold finger
www.dfi .com