Source Audio Soundblox Pro User Manual page 19

Select either the X or Y axes by turning the knob to the right or the left,
respectively. Once an axis is selected, turn the knob toward either ex-
treme labeled to smooth out fast changes from the sensor signal.
SLOW
Turning the knob towards provides the most amount of smoothing
SLOW
causing the effect to react to only large, deliberate motions of the sensor.
Turning the knob all the way to sets the smoothing at a minimum.
FAST
This means that fast changes in the sensor signal will be applied to the
effect and the motions created from normal picking will be enough to
move the filter.
Calibration
The Pro has a calibration feature that is only used in Hot Hand
BEF
mode. However, calibration is not required before use. The calibration
feature allows you to set the midpoint of the filter sweep for any posi-
tion of your hand. Depending on your playing style, you may find it useful
to try some different calibration positions. The most common use of
calibration is setting your resting hand position on the guitar to be the
midpoint of the filter sweep. Calibration can also be useful if you are put-
ting the sensor on a headband or other alternate locations.
To perform a calibration:
1. Select a preset by pressing a footswitch.
2. Select Hot Hand mode with the button.
MOD SOURCE
3. Press and hold the button to put the into
MOD SOURCE BEF Pro
Calibrate Mode. The Hot Hand will begin to blink slowly.
LED
4. Put the Hot Hand sensor into the desired calibration position.
5. Press the footswitch for the currently selected preset.
6. The Calibrate will blink until the calibration is complete.
LED
Note: Calibration can be cancelled by pressing the button
MOD SOURCE
again.
If you have trouble with calibration and need to get back to the default
setting, place the sensor on a flat, level surface with the blue facing
LED
down and run the calibration procedure again.
Use with Hot Hand | 19