Operating Instructions; Shut Down Instructions - ADC ADH-120 Installation Manual

K. OPERATING INSTRUCTIONS
NOTE: Before attempting to start the dryer make sure that the main door and lint door is closed.
1. To Start The Dryer.
a. Microprocessor controller (computer) dryers
1) Display will read "FILL" (meaning no cycle in progress).
2) Press the letter on the keyboard (touch pad) corresponding to the cycle desired (i.e., "E")...
a) The dryer will then start (rotate).
3) Light emitting diode (L.E.D.) display will now show the cycle in progress and cycle status (i.e.,
"dr30") meaning that the dryer is in the drying cycle (dry mode for 30 minutes) and count down in
minutes.
NOTE: Pressing keyboard (touch pad) key "A," "B," "C," "D," and "F" will also start the dryer. The
six (6) preprogrammed drying cycles ("A" through "F") have been stored in the microprocessor
controller's (computer's) memory. Refer to the Computer Programming Manual supplied with
dryer for more specific operating information.
NOTE: The dryer can be stopped at any time by pressing the "CLEAR/STOP" key. To restart the
dryer, press the "ENTER/START" key or preprogrammed cycle key (i.e., "E").
NOTE: Selection (setting) changes can be made at any time during the drying cycle by pressing the
"CLEAR/STOP" key twice. The L.E.D. display will return to "FILL" at which time a new
cycle selection can be made.
L. SHUT DOWN INSTRUCTIONS
If the dryer is to be shut down (taken out of service) for a period of time, the following must be performed:
1. Discontinue power to the dryer either at the external disconnect switch or the circuit breaker.
2. Discontinue the steam supply.
a. SHUT OFF steam valves in the supply lines and the return lines.
33