Preoperational Instructions - ADC ML-30V Installation Manual

Preoperational Instructions _________

Coin Models
Microprocessor Controller (Computer)
• When the microprocessor controller (computer) is in
the ready state, the L.C.D. screen will display "READY,
INSERT $XX.XX (AMOUNT) TO START".
• Insert coin(s). Once the correct "Amount to Start" has
been inserted, the L.C.D. will display "SELECT
TEMPERATURE".
• Select temperature by pressing "HI", "MED", or "LO".
The cycle will start and the L.C.D. will display the Dry
Cycle selected and the remaining time.
• The dryer will continue through the drying and cooling
cycles, until the vended time has expired.
• Upon completion of the drying and cooling cycles, the
tone (buzzer) will sound and the dryer will go into the
Anti-Wrinkle Mode for 99 minutes, or until the main door
has been opened.
NOTE: To stop dryer, open main door or pressing the
"PAUSE" key. Continuation of the cycle will resume only
after the door has been closed and any of the three
temperature selection is pressed.
IMPORTANT: For more detailed information regarding the
microprocessor controller (computer) on your dryer, refer
to the microprocessor user's manual included with the
dryer.
Mechanical Drop /
Rotary Coin Meter or Slide Coin Meter
• Insert coin and turn knob (rotary type meter), or for slide
meter unit, push in coin chute.
• Select Temperature.
• Push the "Start" button.
• To stop dryer, open the main door.
Non-Coin Models
• The L.E.D. display reads "Ready" (no cycle in progress).
• Press the letter on the keypad corresponding to the
cycle desired (i.e., key "D").
• The dryer will then start. (I.E., blower, tumbler, and
heat.)
• The L.E.D. display will read "MANUAL DRYING CYCLE
D, 00:00 MIN REMAIN".
• When the programmed drying time has expired, the
Phase 7 non-coin microprocessor controller (computer)
will proceed into the Cool Down Cycle.
• Once the Cool Down Cycle begins at the end of the heat
cycle, the L.E.D. display will read "COOL DOWN TEMP
___/___ MINUTES REMAINING". At the end of the heat
cycle, the dryer will shut off the heat and continue the
fan and tumbler until the Cool Down Time or
temperature is reached.
113229 - 25
NOTE: "0-40" will require the "START/ENTER" key to be
pressed after the number is selected in order to accept
the selection and start drying.
Press and hold the "UP ARROW" to view the tumbler
temperature at any time.
The dryer can be stopped at any time by pressing the
"STOP/CLEAR" key, at this time the dryer will go into a
cycle pause. If the "STOP/CLEAR" key is pressed again
at this point, the cycle that was in progress will be
cancelled and returned to the "READY" state.
Press and hold the "DOWN ARROW" to view the tumbler
RPM.
IMPORTANT: For more detailed information regarding the
microprocessor controller (computer) on your dryer, refer
to the microprocessor user's manual included with the
dryer.
Dual Timer Dryers
• Turn drying timer knob for a time of 20 minutes.
• Select "High Temp".
• Push "Push to Start" button.
• To stop dryer, open the main door.
Spin and dwell (stop) times are adjustable at the reversing
timer.
www.adclaundry.com 19