Troubleshooting Of Minor Faults - Bosch Vision 500 series Operating, Care And Installation Instructions Manual

Troubleshooting of Minor Faults

d WARNING
TO AVOID
RISK OF ELECTRIC SHOCK!
Repairs should only be carried out
by an authorized technician.
Fault
Cycle duration extended.
The door cannot be
opened.
Door cannot be opened,
even though the appliance
has been switched off and
on again.
Control lights do not light Control lights do not light
up. up.
Cycle does not start.
Start/Pause indicator light
flashes.
Cycle does not start.
Indicator light Finished" is Indicator light Finished" is
lit and display is flashing
E:01"
Cycle does not start. Real
Time delay" is indicated in
the display field.
Spin speed cannot be
selected.
Detergent residue in the
detergent dispenser.
If repairs are necessary, and you
cannot eliminate the fault yourself with
the aid of the table below, follow these
steps:
1. Turn the cycle selector to Off.
2. Disconnect the washing machine
from the power outlet.
3.
Turn off the water faucets.
4. Call Customer Service
(refer to Page 31).
Possible cause
This is not a fault.
The suds detection feature has activated an additional
rinsing cycle to reduce the amount of suds.
This is not a fault.
The unbalance compensation system is attempting to
balance the load through repeated spins.
This is not a fault.
The laundry load may be large, requiring more time.
Power failure.
Cycle is running and/or the door is locked for safety
reasons.
Plug is loose or not inserted.
Cycle selector turned to Off before end of cycle.
For safety reasons the door has been locked because the
water level, temperature or high drum speed.
A fuse has blown. A fuse has blown.
Power failure.
Start/Pause button not pressed.
Door not closed properly.
End time selected and activated.
Spinning is already in progress; during spin cycle the
speed cannot be changed.
Detergent was damp or lumpy.
Troubleshooting items listed below may
not be covered by warranty service!
Please carefully rule out any of these
issues before calling for service.
Action
Add a more appropriate amount of detergent.
Always load the drum with large and small items
together.
Allow additional washing time for larger loads.
An interrupted cycle will be resumed when power is
restored. If the laundry is to be removed during a power
failure, call Customer Service (refer to Page 31).
Wait until the cycle ends (see Page 26).
Eliminate the cause.
Select a cycle.
See "Adding to the laundry/Interrupting the cycle", Page
26 .
Reset circuit breaker.
Call Customer Service if this fault recurs.
An interrupted cycle will be resumed when power is
restored. If the laundry is to be removed during a power
failure, call Customer Service (see page 31).
Press the Start/Pause button.
Check whether laundry is trapped in door.
Close the door (a click should be heard).
cycle continues.
None. Appliance starts automatically.
Select speed before spinning.
Clean and dry the detergent dispenser (see Page 27).
Use the cap of the detergent bottle to measure liquid
detergents.
29