Troubleshooting Of Minor Faults - Bosch Nexxt 500 Series Operating, Care And Installation Instructions Manual

Troubleshooting of Minor Faults

d
WARNING
TO AVOID RISK OF ELECTRIC
SHOCK!
Repairs should only be carried out
by an authorized technician.
Fault
The door cannot be The door cannot be
opened. opened.
Door cannot be opened,
even though the appliance
has been switched off and
on again.
Control lights do not light Control lights do not light
up. up.
Program does not start.
Start/Pause indicator light
flashes.
Program does not start.
Indicator light end" is lit Indicator light end" is lit
and display is flashing
E:01"
Spin speed cannot be
selected.
Detergent residue in the Detergent residue in the
detergent dispenser. detergent dispenser.
Water does not enter the
machine or detergent is machine or detergent is
not washed away. not washed away.
Indicator light spin" is lit Indicator light spin" is lit
and display is flashing and display is flashing
E:02" or E:03". E:02 E:03
Water cannot be seen in
drum.
Indicator light rinse" is lit
and display is flashing
E:04" with no water re
maining in tub.
If repairs are necessary, and you
d
cannot eliminate the fault yourself with
the aid of the following table:
Turn the program selector to Off.
q
Disconnect the washing machine
q
from the power outlet.
Turn off the water taps.
q
Call Customer Service
q
(refer to Page 25).
Possible cause
No final spin" selected.
Power failure.
Program is running and/or the door is locked for safety
reasons.
Plug is loose or not inserted.
Program selector turned to Off before end of program.
For safety reasons the door has been locked because the
water level, temperature or speed is too high.
A fuse has blown. A fuse has blown.
Power failure.
Start/Pause button not pressed.
Door not closed properly.
Spinning is already in progress; during spin cycle the
speed cannot be changed.
Program selector is set to drain; spin cycle is not
possible with this program.
Detergent was damp or lumpy. Detergent was damp or lumpy.
Water tap(s) not turned on.
Supply hose kinked or pinched.
Strainers in supply hose clogged.
Water pressure too low.
This is not a fault.
The water level is below the visible part of the drum.
Suds or pump is blocked.
Action
Select Drain or Spin.
An interrupted program will be resumed when power is
restored. If the laundry is to be removed during a power
failure, call Customer Service
(refer to Page 25).
Wait until the program ends; see Page 21.
Eliminate the cause.
Select a program.
See "Add a garment/Interrupting the program", Page 20.
Reset circuit breaker.
Call Customer Service if this fault recurs.
An interrupted program will be resumed when power is
restored. If the laundry is to be removed during a power
failure, call Customer Service
(refer to Page 25).
Press the Start/Pause button.
Check whether laundry is trapped in door.
Close the door (a click should be heard).
Program continues.
Select speed before spinning.
If required, select another program.
Clean and dry the detergent dispenser; see Page 21.
Use the cap of the detergent bottle to measure liquid
detergents.
Turn on water tap(s) and press Start/Pause button.
Program continues.
Eliminate the cause
.
Clean the water inlet strainers; see Page 21.
Eliminate the cause.
Use less detergent for future wash loads. Detergents
specifically designed for you High Efficientcy washer
produce fewer suds and will include the letters HE"
on the packaging. Clean the water drainage pipe
and/or drain hose. Turn the program selector to off"
and restart Drain program.
23