Change To Straight Stitch Plate - Husqvarna Viking Designer Diamond Royale User Manual

screw.
2. Place the dual feed on your machine from the back,
screw the dual feed onto the presser foot bar with the
presser foot ankle screw. Reduce presser foot pressure
to 3.
Snap-on and remove the presser foot
3. With presser foot bar in the up position, place the
presser foot under the dual feed.
4. Push the foot upwards so that it snaps into place.
upwards until the foot snaps off.
Note: Always keep the dual feed with a foot snapped-on when it is
not attached to the machine.
How to attach the guide
The two guides included with the dual feed will help you
sew parallel rows of stitching side by side as in channel
one for the right.
6. Insert the guide into the hole in the back of the dual
feed.
pulling it to the left or to the right.
Note: Look for optional dual feed accessories at your
HUSQVARNA VIKING
CHANGE TO STRAIGHT STITCH
PLATE
the fabric from being pulled down into the bobbin area,
especially at the beginning and/or end of a seam.
2. Make sure that the feed teeths are lowered. Place the
needle plate.
3. With feed teeths lowered, place the straight stitch plate
2:10
® retailer.
2 Set Up
1.
3.
6.
1.
3.
D
2.
4.
5.
2.