Hangar 9 46% TOC Ultimate 10-300 Assembly Manual page 14

Section 4: Gluing the Aileron Hinges
Note: Be sure that the hinge pivot pins are
parallel and flush to the trailing edge. It's
important to frequently mix a fresh batch of
30-minute epoxy in order to achieve good glue
joint penetration. If you notice the epoxy
becoming thicker, mix a new batch.
Step 2
Mix 1 ounce of 30-minute epoxy. Lightly coat each hinge
using an epoxy brush or mixing stick. Use a syringe or
toothpick to place a sufficient amount of epoxy in each
hinge pocket in the wing. Place the hinges in the same
positions to make the installation in the wing easier.
14
Step 3
Carefully slide the aileron onto the wing. Remove any
excess epoxy using a paper towel and Denatured alcohol.
Apply even pressure to avoid twisting the aileron and
damaging the hinge pockets or hinges.