Indicator Lights - HotSpring Vista Owner's Manual

The four labeled outer buttons are referred to as "Hard buttons". These buttons are fixed and their functions do not change.
The four inside buttons are referred to as "Soft buttons". Pressing the soft button will activate the function on the screen closest to the
button. The control panel display responds to let you know you've pressed a button and that the selected function has been performed.
After a period of non-use (45 seconds) the display will go back to the Home screen where the screen will remain on for several minutes
before going to the sleep mode. Pressing any button will wake up a sleeping display.
HARd bUTTONS
JeTS - If jet pump indicator light is off and JETS hard button is pressed, the 1st jet pump function will activate and the main control panel
display will advance to the Jets menu.
If jet pump indicator light is on and the JETS hard button is pressed from any screen other than the Jets menu, the jets pump function
does not change, only the main panel screen will change to the Jets menu.
lIgHTS - If lights are off, press from any screen to turn on the Underwater lights (only) and display the Underwater lighting menu. When
pressed in the Underwater menu with the underwater lights on, it will cycle the light intensity for the underwater lights. If underwater
lights are on, initial press of lights hard button will not change light setting but will access Underwater lighting menu.
OPTIONS - Transitions to the Options screen to access temperature and setup menus.
bACk - Goes back one menu. In Home screen Hold BACK button until screen rotates 180° to view from inside spa. Repeat to reverse.
Control panel screen

INdICATOR lIgHTS

At a glance, the indicator lights are readily visible on the main control panel. The seven LED indicator lights work independently from
the rest of the control panel display. That way, even if the control panel is sleeping, you can simply glance at the indicator lights to
determine the status of your spa.
ReAdy Indicator: The READY indicator will light when the spa water temperature is within 2°F (1°C) of the set temperature,
and will turn off when the temperature is outside of that range. If you increase or decrease the temperature setting of the spa,
the ready indicator will turn off until the spa temperature reaches the acceptable range for the new set temperature. Additionally, a
flashing READY indicator indicates that a problem exists with the temperature sensor (see Troubleshooting section for more information)
Summer Timer Indicator: The Summer Timer indicator is lit when the Summer Timer is set to ON. In the summer timer
mode, the heater and circulation pump remain off for eight hours. Summer Timer indicator will not flash.
Spa light Indicator: The Spa Light indicator is lit when any light inside the spa is on. The indicator will remain solid as long
as the spa light is activated. Spa Light indicator will not flash.
Spa or Temperature lock Indicator: The Spa or Temperature Lock indicator is lit when either the Spa Lock or Temperature
Lock is activated. Lock indicator will not flash.
Jet Pump Indicator: The Jet Pump indicator is lit whenever a jet pump is on. The jet pump indicator will flash whenever the
spa is in the ten-minute clean cycle.
Water Care Indicator: The Water Care indicator is lit whenever a water care device is detected in the system and the water
care system is operating correctly. The icon will flash if the water care system requires attention.
POWeR Indicator: The POWER indicator is 'on' when the spa is properly supplied with power. It also provides a diagnostic
function–a flashing power indicator indicates that the heater high limit has tripped, meaning that either the spa water is above
its acceptable temperature range, or a malfunction has occurred within the spa (such as low circulation due to clogged filters).
An 'off' power indicator means that there is a problem with the spa control box or the power supplied to the spa (see Troubleshooting
section for more information).
Indicator lights
Page 30
Hard button
Soft button
control panel operations