Norcold 8682 Repair Manual page 18

25. With Mode Selector still set to
Gas Mode, check for 12 Volts
DC at the connector between
the Power Supply board and
Ignition Module (first wire from
left) as shown in Figure 5.31.
If you do not have 12 volts, re-
place the Power Supply.
26. If you have 12 volts and the
gas solenoid valve did not
open or the Ignition electrode
did not spark the Burner, pro-
ceed to next step.
27. Check for 12 Volts DC across
the terminals of the gas valve.
If 12 volts (10.5 volts min.) is
present and the valve did not
open, replace the valve. If wir-
ing is proper and 12 Volts
(10.5 Volts min) is not present,
replace the Ignition Module.
Note:
The valve will only have 12 volts
when the flame is burning or dur-
ing a trial for ignition.
28. If the Ignition electrode did not
send sparks to the Burner,
check the electrode wire for
continuity as shown in Figure
5.33. If Electrode wire shows
continuity, proceed to next step.
Figure 5.31 12 Volt Check At Ignition Module
Figure 5.32 12 Volt Check At Gas Valve
Figure 5.33 Continuity Check Of Electrode Wire
5-18