Page 1
Read this Guide. For assistance or additional information consult a qualified installer, service agency, or the gas supplier. Part No.: 618612C(96-09) 9100 Series Refrigerators Operator’s Guide for Models: 9162 9182 9163 9183 FOR YOUR SAFETY WARNING NORCOLD P O BOX 4248 SIDNEY OH 45365-4248...
12 volts DC control voltage (10.5 VDC min to 15.4 VDC max.) DC Operation 3-Way Models Onl y. 12 volts DC (11.5 VDC min. to 15.4 VDC max.) Operating in excess of these specifications can damage the refrigerator’s electrical circuit, related components and voids the refrigerator’s warranty. Table of Contents Diagnostics Diagnostics and Corrective Action ...
Improper installation, adjustment, alteration, servicing or maintenance of this refrigerator can cause personal injury and property damage. Service and maintenance is to be done by your dealer or a Norcold authorized service center. Use extreme care when working with or near a propane gas system. Do not smoke or create sparks.
Norcold refrigerators are the only RV refrigerators manufactured in America. Your 9100 series refrigerator is the only RV refrigerator to offer a standard limited 2-year warranty. Norcold also offers additional warranty coverage (2+3 Plan) which extends the standard 2-year warranty an additional 3 years for a total of 5 years protection.
Moisture Reduction Heater This refrigerator has a heater to prevent moisture from forming on the center divider between the freezer and fresh food compartment doors. The heater starts and stops when the refrigerator is turned On and Off .
Strip of paper Repeat all around the door. If the paper does not have a noticeable drag, the gasket is not sealing. Contact your dealer or a Norcold service center to correct this. Adjustable Shelves Multiple shelf grooves in the freezer and...
The AC, LP GAS, Battery, and AUTO LED’s (A) light indicating the operating mode. ON/OFF (E) turns the refrigerator On or Off. If the refrigerator is Off, press this to turn it On and set the mode to AUTO. If the unit is On, press this for 2 seconds to turn the refrigerator Off.
The LED flashes until the refrigerator is turned OFF and then ON. If gas does not ignite after several attempts, check input gas supply, or consult your dealer or a Norcold authorized service center. Select a different operating mode by pressing and holding MODE . The refrigerator does not switch to the new operating mode until you release MODE .
Refrigerator Storage When the refrigerator will not be in use for an extended (seasonal) period of time, it is recommended that all power to the refrigerator be disconnected. Unplug the refrigerator’s AC power cord from the wall receptacle and disconnect the 12 volt DC supply wires from the refrigerator’s power board located at the rear of the refrigerator.
Figure 12 1. Remove the refrigerator from its enclosure. Follow "Refrigerator Removal and Replacement" procedure beginning on page 11. 2. Remove the heat deflector cap from the flue. 3. Remove the spiral flue baffle from the flue tube. 4. Using a stiff brush or fine emery cloth, clean the spiral flue baffle of debris.
DC Heater Circuit - 20 amp (yellow) blade-type automotive AC Circuit - 5 amp glass cartridge 10. If a fuse continues to blow, contact your dealer or a Norcold Service Center for corrective action. 5 Amp Glass Cartridge AC Fuse...
If a diagnostic indicator appears, see Diagnostics . If the refrigerator is operating on gas and a loss of cooling is noticed, switch the refrigerator to AC mode of operation (see Start-Up Instructions ). If the refrigerator has been operating on electric, switch to gas operation.
Norcold and advice will be promptly given concerning the manner in which warranty service may be obtained. Inability to physically bring the refrigerator to a Norcold Service Center will not void the warranty, but any additional costs thereby incurred are solely for the account of the original consumer-purchaser.