Password Level - Intec MGC2-16 User Manual

PolyGard Multi-Point Controller
®
User Manual - MGC2-16
2.3

Password Level

All changes of parameters and staged setpoint values are protected by four digit numeric Code (= password).
The code level 1 permits the operation of the MGC2. This code level is intended for the customer. It can be
changed in the System Setup Menu "Change Customer Password"
With the code level 2 all parameters and set points can be changed, this code level is reserved for the service
technician.
A password must be re-entered if there is 15 minutes of inactivity.
All menu windows are visible without a password.
Factory preprogrammed system password "9001".
Polygard® is a registered trademark of MSR
Customer Services (858) 578-7887 & (888) GO INTEC
INTEC Controls, 12700 Stowe Dr., Suite 100, Poway, CA 92064
Fax (858) 578-4633 & (888) FX INTEC
www.inteccontrols.com
Page 06
Specification subject to change without notice.
Printed in USA 131119
MGC2-16