Service Mode - Intec MGC2-16 User Manual

PolyGard Multi-Point Controller
®
User Manual - MGC2-16
EP Module 1
active
EP Module 2
active
EP Module 3
active
EP Module 4
Not active
EP Module 5
Not active
GC- Address
1
Analog Output
3.7.1

Service Mode

If the Service mode is set to (ON) then the stage/setpoints are disabled so relays are not activated during
calibration or service work. The service mode is Reset automatically after 60 minutes or when the service mode is
set to Off.
Symbol Description
Off Service Mode
Polygard® is a registered trademark of MSR
Customer Services (858) 578-7887 & (888) GO INTEC
INTEC Controls, 12700 Stowe Dr., Suite 100, Poway, CA 92064
See 3.7.10
See 3.7.10
See 3.7.10
See 3.7.10
See 3.7.10
Controller address
(Reserved for future expansion; value should be left at "1")
See 3.7.7
Analog Output 1
See 3.7.7
Max.
Calibration AO 1
Siehe See 3.7.7
4.0=4 mA 20 = 20.0
See 3.7.7
Analog Output XX
Max.
Calibration AO XX
See 3.7.7
4.0=4 mA 20 = 20.0
Default
Function
Status
Off = Stages exceeded will activate the assigned relays
Off
On = Stages exceeded will not activate the assigned relays
Fax (858) 578-4633 & (888) FX INTEC
www.inteccontrols.com
Page 20
Specification subject to change without notice.
Printed in USA 131119
MGC2-16