Mounting / Electrical Connection; Electrical Connection - Intec MGC2-16 User Manual

PolyGard Multi-Point Controller
®
User Manual - MGC2-16
4

Mounting / Electrical Connection

The Controller is installed through the 4 marked mounting holes at the back of the housing. These mounting holes
are accessible after opening the housing. See Fig. 01
The mounting holes should be covered with the enclosed caps after installation.
Please consider the following when selecting the mounting place:
 Avoid locations where water, oil etc. may influence proper operation and where mechanical damage might
be possible.
 Install cables only from the Topside.
 On the left side keep at least 150 mm distance to open the transparent door.
 Consider any unusual condition or requirements of the Customer.
Fig. 01
8.7 in. (220 mm)
4.1

Electrical Connection

Installation must be done per local electrical codes with the consideration of the technical requirements of the
product.
The alarms are available as SPDT, potential free contacts.
For the exact position of the terminations of the relays see the following connection diagram.
Polygard® is a registered trademark of MSR
Customer Services (858) 578-7887 & (888) GO INTEC
INTEC Controls, 12700 Stowe Dr., Suite 100, Poway, CA 92064
Fax (858) 578-4633 & (888) FX INTEC
www.inteccontrols.com
Page 24
Specification subject to change without notice.
Printed in USA 131119
MGC2-16