Chapter 2 Basic Setup; Installation - ADT Pulse OC835-ADT Quick Installation Manual

Chapter 2
Basic Setup
This section provides information on how to assemble and configure
the OC835-ADT Outdoor HD Camera.

Installation

1. Assemble the Camera
Attach the Camera Stand to the camera.
2. Make the Connection
Using a Wired Connection
If you are using a wired connection to the OC835-ADT, connect a Micro USB
to RJ-45 Adapter Cable (not included) to the USB port of the camera. Then use
a standard Ethernet cable (not included) to connect to the Pulse Gateway or
Total Security (TS) Base panel.
Using a Wireless Connection
The wireless (WPS) connection between the camera and the Pulse Gateway or
Total Security (TS) Base panel is performed during the Pulse enrollment. This
process is detailed starting on page 15.
Note: The Wireless and LAN interfaces cannot be used
simultaneously. Making a wired LAN connection disables the
wireless interface.
OC835-ADT Outdoor HD Camera Installation Guide
Figure 4: Wired Network Connection
2
9