ADT Pulse OC835-ADT Quick Installation Manual page 21

11. At the location of the power source, connect the power cable to the power
adapter:
•
Screw the red wire onto the positive (+) terminal of the power adapter, on
the left side.
•
Screw the black wire onto the negative (–) terminal of the power adapter,
on the right side.
12. Remove the retaining screw from the receptacle plate and plug the power
adapter into the lower power outlet.
13. Insert the retaining screw through the opening at the top of the power
adapter and reinstall it into the receptacle, securing the adapter to the wall.
14. Adjust the camera to a desired position and secure it firmly.
15. Verify that the camera is active on the wireless network and is recognized by
Pulse.
OC835-ADT Outdoor Day/Night HD Camera Installation Guide
Figure 9: Routing the Power Cable
Chapter 4 Wall Mounting
21