Mount The Camera - ADT Pulse OC835-ADT Quick Installation Manual

Chapter 2 Basic Setup
3. Power Up
Connect the supplied 12V power adapter to the camera and power up. Use
only the power adapter provided. Using a different one may cause hardware
damage.
CAUTION: Use only the power adapter provided. Using a different
one can result in hardware damage.
The Power LED turns on briefly, and then starts blinking. (The Power LED will
continue to blink during startup, which takes about one minute. After startup is
completed, the Power LED should remain ON.)
4. Check the LEDs
•
Power LED. At power up, the Power LED turns on briefly, and then starts
blinking, which takes about one minute. After startup has completed, the
Power LED remains on.
•
Network/WPS LED. At power up, the Network/WPS LED is off.
(The Network/WPS LED will flash amber when the camera attempts to
connect wirelessly to the Pulse Gateway / TS Base. The Network/WPS
LED will turn solid green when the wireless connection is successful.)
5. Enroll the Camera in ADT Pulse
This process is described in the next chapter, ADT Pulse Enrollment.

6. Mount the Camera

Place the camera in a location near a power source. For mounting on a wall
using the mounting plate, see Chapter 4 Wall Mounting on page 19.
10 OC835-ADT Outdoor HD Camera Installation Guide