Brother FAX-2890 Basic User's Manual page 85

Error Message
Replace Toner
Scan Unable XX
(XX = Error Code)
Size mismatch
Toner Ended
Toner Low
Cause
The toner cartridge is at the end
of its life. The machine will stop
printing until you replace the toner
cartridge.
While memory is available, faxes
will be stored in the memory.
The machine has a mechanical
problem.
The paper in the tray is not a
correct size.
It is time to replace the toner
cartridge.
While memory is available, faxes
will be stored in the memory.
If the LCD shows Toner Low you
can still print; however, the
machine is telling you that the
toner cartridge is near the end of
its life.
Troubleshooting
Action
If you have set the Toner setting to Stop,
replace the toner cartridge with a new and
unused original Brother toner cartridge. This
will reset the Replace Toner mode. (See
Replacing the toner cartridge uu page 50.)
If you have set the Toner setting to
Continue, the machine will continue to
print data until the LCD shows Toner
Ended. For how to operate the machine in
Continue mode, see Advanced User's
Guide: Toner Settings.

 (For FAX-2890)
See Transferring your faxes or Fax
Journal report uu page 78 before
disconnecting the machine so you will
not lose any important messages. Then,
turn the power switch off, wait a few
seconds, and then turn it on again.
Leave the machine for 15 minutes with
the power on.
(For FAX-2990 and MFC-7290)
Turn the power switch off, wait a few
seconds, and then turn it on again.
Leave the machine for 15 minutes with
the power on.
 If the problem continues, call Brother
Customer Service or your local Brother
dealer.
Load an appropriate size of paper in the
tray, and re-set the "Paper Size" (Menu, 1,
2, 2). (See Paper Size uu page 17.)
Replace the toner cartridge with a new one.
(See Replacing the toner cartridge
uu page 50.)
Order a new toner cartridge now so a
replacement toner cartridge will be available
when the LCD shows Replace Toner or
Toner Ended.
B
77