Anti-Tilting Plate - Technika TEE54SS Instructions For Use And Installation

Installation

Anti-tilting plate

The cooker is supplied with an anti tilting plate to prevent it from
tipping. Install the plate as follows:
· Determine the position of cooker and anti-tilt plate.
· Securely fix the anti-tilt plate to the floor with appropriate
fasteners.
· Fasten the stability bolt bracket to the front frame with the 2
screws supplied.
· Reposition the cooker back into the anti-tilt plate and then mark
the position of the stability bolt hole.
· Pull the cooker back out and drill the bolt location hole. Use a
10mm masonry or wood drill. When drilling into concrete ensure
a minimum hole depth of 30mm.
· Reposition the cooker back into the anti-tilt plate, aligning the
stability bolt bracket with the 10mm drilled hole. Then slide the
bolt through the bracket and into the hole.
· Connect Electricity supply but do not turn on until installation is
completed.
· Slide the cooker back into the anti-tilt plate so that rear cover
rests against the rear wall. Then check the height and level of
the cooker. If required, pull the cooker back out and adjust the
levelling feet as required. (unit to be 10mm above bench height).
WARNING: In order to prevent accidental tipping of the
appliance, for example a child climbing onto the open oven
door, the stabilising means must be installed. Ensure the plate
is correctly anchored to prevent the appliance from tilting
forward.
MAKE SURE THE ANTI-TILTING PLATE PREVENTS THE
APPLIANCE TILTING.
30