Light Emitting Diodes (Led) On Charger; Switching On - Stihl MSA 160 C Instruction Manual

English
Light Emitting Diodes
(LED) on Charger
1
The light emitting diode lights up green
or flashes red.
Green continuous light ...
... means the following:
The battery
– is being charged
– is too hot and must cool down
before it is charged
See also "Light Emitting Diodes (LED)
on Battery".
The green light emitting diode on the
charger goes off as soon as the battery
is fully charged.
Red flashing light ...
... means the following:
24
– No electrical contact between
battery and charger – remove and
refit the battery
– Faulty battery – see also "Light
Emitting Diodes (LED) on Battery".
– Charger faulty – have checked by a
servicing dealer. STIHL
recommends a STIHL servicing
dealer.

Switching On

When delivered, the battery is charged
to a charge state of approx. 30 %.
It is advisable to charge the battery
completely before using it for the first
time.
N Before inserting the battery, remove
the battery compartment cover if
there is one; to do this, press both
safety catches at the same time –
cover is unlocked – and remove the
cover
Insert battery
N Insert battery in the battery
compartment of the machine –
battery slides into the compartment
– press gently until it clicks into
place – top of battery must be flush
with the top edge of the housing
Switching on the machine
N Assume a firm and secure stance
N Ensure that there are no other
persons within the swivel range of
the machine
MSA 160 C