Part names and
functions
Infrared sensor
LED indicator
MHIGHN/MLOWN
Used to change the sensor
sensitivity (page 15).
Rear cover
M
Used to confirm the status of the
sensor or register the sensor to
the hub.
LED indicator
You can press M
LED indicator to confirm the sensor's
status.
Indicator
Green, lit
Red, lit
HNS102AZ_(en_en)_0325_ver.031.pdf
A
B
C
E
N
N and check the
Status
No motion detected
Motion was detected
7
Indicator
Status
Red,
Sensor is out of range
blinking
of the hub
Green,
Registration mode
blinking
(You pressed and held
M
Off
No battery power
Note:
R The LED indicator does not indicate
sensor status if the sensor has not
been registered (page 8).
Setup overview
D
1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Insert the batteries
The motion sensor is battery
powered.
3
Registration
Required only if the motion sensor
was purchased separately (i.e.,
not as part of a bundle).
4
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
5
Installation
Install the motion sensor in the
desired location.
Setup
N)
7
2015/03/25
14:24:03