Jack; Multi Access Port; Headphone Jack; D.s.c. Jack - Ko Propo EX-10 Eurus Instruction Manual

Transmitter (rear)
Charging jack
(refer to P10)

D.S.C. jack

By connecting receiver and servo directly with transmitter using D.S.C. (Direct Servo Control), you can configure settings
without transmitting radio wave in pit area or near R/C circuit (D.S.C. cable (optional available) required).
1.
Turn off transmitter and remove rubber cover from D.S.C. jack. Connect D.S.C. cable (transmitter will be turned on
automatically).
2.
(For KR-409S receiver) Press both +/- keys to choose Digital mode (see P25).
(For PPM receivers) Choose response mode NORM, HSP or ADV (see P25).
3.
Connect D.S.C. cable to battery channel in receiver.
Caution!
Remove crystal from receiver before connecting.
4.
Connect receiver with battery using the channel not employed (such as CH3).
5.
Connect servo with receiver and set up.
6.
Disconnect battery from receiver first, and then detach D.S.C. cable from transmitter.

Multi Access Port

Connecting Data Pack (optional available) or ICS Communication Adaptor/ICS USB Adaptor (optional available) using Multi
Access Port will allow for more fine data management.
Data Pack (optional available)
ICS Communication Adapter/ICS USB Adapter (optional available)

Headphone jack

A jack for headphone/earphone (Φ3.5mm / separately available).
During headphone or earphone connected, beeps from transmitter are effective. Headphone jack is monaural output.
8
RF Module
Use only a module included in this set or one that is
compatible with the set.
Multi Access Port
Extra 10 model memories are available (refer to P17).
Allows for fine data controlling using a PC.
(refer to P11)
Headphone jack
D.S.C. jack
(refer to P8)
(refer to P8)
Receiver
(refer to P8)
Battery channel