Unit Preparation; Battery Installation - Ko Propo EX-10 Eurus Instruction Manual

Unit preparation

Unit preparation

Battery installation

1.
Slide battery box lid, pressing triangle on
the lid.
2.
Install R6/AA/UM3 batteries ×8 in the battery box. Note
contact points.
Note polarity and use fresh batteries. Depleted batteries
may deteriorate radio power and cause malfunction.
Caution!
Do not use high voltage dry batteries (such as Lithium) because
the voltage is too high and may damage the transmitter.
Battery Pack (optional available)
A chargeable battery pack (optional available)
Installation
Connect battery cable and store it in transmitter.
Apply buffer sponge on battery box lid inside.
Caution!
Be sure not to miss polarity of battery pack.
Be sure to connect battery cable correctly when using battery pack
other than KO genuine products. Always refer to the illustration in
the manual before battery installation.
Charging
Connect KO genuine AC100V charger or DC12V quick charger
with charging jack as shown.
For AC100V charger, charge battery pack for 14-18 hours
after discharged.
Caution!
Never charge R6/AA/UM3 batteries through transmitter. It will
occur leakage or burst, leading to serious damage of
transmitter.
Caution!
When discharging battery pack, always remove it from
transmitter (do not discharge using charging jack).
Caution!
Be careful that charging current does not exceed 1A.
Caution!
Read carefully and fully understand instruction manual
included in battery pack.
10
Transmitter (bottom)
Battery box
Not used.
Battery box lid
Contact
R6/AA/UM3 battery ×8
Note polarity.
Battery Pack
AC charger
DC12V quick charger