Handlebar Position; Adjusting The Handlebar Position - Husqvarna 2014 FC 450 EU Owner's Manual

10 TUNING THE CHASSIS
10.14

Handlebar position

10.15

Adjusting the handlebar position

Guideline
Rebound damping
Comfort
Standard
Sport
Info
Turn clockwise to increase damping; turn counterclockwise to reduce damp-
ing.
–
Mount protection caps
On the upper triple clamp, there are two holes at a distance of
Hole distance A
The holes on the handlebar support are placed at a distance of
Hole distance B
The handlebar can be mounted in four different positions. In this way, the handlebar can
be mounted in the position that is most comfortable for the rider.
800116-10
x
–
Remove screws
to one side.
Info
Protect the components against damage by covering them.
Do not bend the cables and lines.
–
Remove screws
–
Place the handlebar supports in the required position. Mount and tighten screws
B00375-10
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten screws
Guideline
Screw, handlebar clamp
14 clicks
12 clicks
10 clicks
1
.
15 mm (0.59 in)
3.5 mm (0.138 in)
1
. Take off the handlebar clamps. Take off the handlebar and lay it
2
. Remove the handlebar supports.
M10
M8
A
to each other.
B
from the center.
40 Nm Loctite ® 243™
(29.5 lbf ft)
1
evenly.
20 Nm (14.8 lbf ft)
31
2 .