Rack Mounting - Planet FGSW-262 User Manual

presented.
To install your Switch on a desktop or shelf, simply complete the following steps.
2.2.1 Desktop Installation
To install a Switch on a desktop or shelf, simply complete the following steps:
Step1: Attach the rubber feet to the recessed areas on the bottom of the Switch.
Step2: Place the Switch on a desktop or shelf near an AC power source.
Step3: Keep enough ventilation space between the Switch and the surrounding
objects

Note:
Step4: Connect your Switch to network devices
A. Connect one end of a standard network cable to the 10/100 or 10/100/
1000Mbps RJ-45 ports on the front of the Switch.
B. Connect the other end of the cable to the network devices such as
printer servers, workstations or routers...etc.

Note:
Step5: Supply power to the Switch.
A. Connect one end of the power cable to the Switch.
B. Connect the power plug of the power cable to a standard wall outlet
then power on the Switch.
When the Switch receives power, the Power LED should remain solid Green.

2.2.2 Rack Mounting

To install the Switch in a 19-inch standard rack, follow the instructions described below.
Step1: Place your Switch on a hard flat surface, with the front panel positioned
towards your front side.
Step2: Attach a rack-mount bracket to each side of the Switch with supplied
screws attached to the package. Figure 2-3 shows how to attach brackets
to one side of Switch.
When choosing a location, please keep in mind the environmental
restrictions discussed in Chapter 1, Section 4, Specification.
Connection to the Switch requires UTP Category 5 network
cabling with RJ-45 tips. For more information, please see the
Cabling Specification in Appendix A.
7