Installing An Sfp+ Optical Transceiver - Lenovo RackSwitch G8052 Installation Manual

Installing an SFP+ Optical Transceiver

50
RackSwitch G8052 Installation Guide
Approved 10 GbE SFP+ optical transceivers are supported in G8052 SFP+ ports.
The SFP+ optical transceiver provides two fiber-optic cable connectors for
connecting to external ports.
Statement 3
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
•
Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
•
Use of controls or adjustments or performance of procedures other than
those specified herein might result in hazardous radiation exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view directly
with optical instruments, and avoid direct exposure to the beam.
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
Appareil À Laser de Classe 1
To install an SFP+ optical transceiver into an SFP+ slot on the switch, complete the
following steps.
Note: To avoid damage to the cable or the SFP+ transceiver, do not connect the
cable before you install the transceiver.
1. Remove the safety cap and pull the locking lever into the down (unlocked)
position.
2. Insert the transceiver into the switch port until it clicks into place. Use minimal
pressure when you insert the transceiver into the slot. Do not use excessive
force when you insert the transceiver or you might damage the transceiver or
the slot.
The transceiver has a mechanical guide key to prevent you from inserting the
transceiver in an incorrect orientation.
3. Pull up the locking lever to lock the transceiver into place.