Installing An Sfp+ Module - Lenovo BladeCenter Virtual Fabric 10Gb Switch Module Installation Manual

Installing an SFP+ module

The SFP+ module provides two fiber-optic cable connectors for connecting to
external ports. To install an SFP+ module, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. If you have not already done so, touch the static-protective package that
3. Read the information in "Handling an SFP+ module" on page 15.
4. Remove the SFP+ module from its static-protective package.
5. Remove the protective cap, if one is installed, from the SFP+ module port
6. Remove the protective cap from the SFP+ module and store it in a safe place.
7. Insert the SFP+ module into the SFP+ module port until it clicks into place.
8. Connect the fiber optic cable (see "Connecting the SFP+ module cable" on page
on page 8.
contains the SFP+ module to an unpainted metal surface of the BladeCenter
chassis or an unpainted metal surface on any other grounded rack component in
the rack in which you are installing the switch module for at least 2 seconds.
where you are installing the SFP+ module and store it in a safe place.
Attention: To avoid damage to the cable or the SFP+ module, make sure that
you do not connect the fiber optic cable before you install the SFP+ module.
20) and any cables that you disconnected earlier.
Chapter 3. Installing and removing a 10 Gb SFP+ module
17