Table of Contents
Advertisement
38
RackSwitch G8052 Installation Guide
To install the G8052 in a System x or Power rack, complete the following steps:
1. Locate, record, and retain the product switch information in order to configure
and register your product. See
page
30.
Note: If this switch is a replacement switch, copy the product information from the
original switch onto the RID label that is shipped with replacement switch
and affix the new label to the bottom of the new switch.
2. Remove the rear cover screws:
3. Use M4 screws to attach the front mounting brackets to each side of the switch.
Torque the screws to approximately 2.0 newton-meters (Nm) ± 0.1 Nm (17.7
inch-pounds).
9
"Recording Important Product Information" on
9
1
7
Hide quick links:
Advertisement
Table of Contents
