Information Codes Table (For Facsimile) - Panasonic DP-C405 Service Handbook

3.6.

Information Codes Table (For Facsimile)

Code Mode Phase
012 RCV
030 XMT
031 XMT
COPY
061 -
212 XMT
RCV
400 XMT
401 XMT
402 XMT
403 RCV
(Polling)
404 XMT
405 XMT
406 RCV
(Password
Comm.)
Ver. 1.1
Fax Information Codes
Description of Problem
C, D The length of the received
document is over 2 m.
B Read Point Sensor does not
activate within 10 seconds after the
document starts feeding.
C Transmitting document was longer
than 2,000 mm (or 78.7 in).
(Super Fine / 600 dpi: 1,387 mm
(or 54 in))
A ADF Door is open.
A-E Interface error occurred between
the CPU and modem.
B T1 timer (35±5 sec) elapsed
without detecting 300 bps signal.
B DCN was returned from receiver
while transmitter is waiting for CFR
or FTT.
B DCN was returned from receiver
while transmitter is waiting for NSF/
DIS.
B Transmitter had no polling function. "POLLED=ON" (polling XMT ready) is
B Transmitter sent NSS (or DCS)
followed by TCF three times, but
the receiver did not respond. (CFR
or FTT is usually returned)
B Transmitter received FTT after it
transmitted TCF at 2400 bps.
Received RTN after communicating
at 2400 bps.
B XMT-Password mismatched. RCV-
Password mismatched.
Selective RCV incomplete.
Transmitter Document Jam.
Document is not set properly.
Defective Read Point Sensor.
The document may jam.
Defective Read Point Sensor.
Cover is not firmly closed.
Connectors are not firmly connected.
Modem is defective. (FCB PCB)
Software problem occurred. (SC PCB)
The line is defective.
Wrong number is dialed and the START
button is pushed.
Telephone line is disconnected while
dialing.
FCB PCB (Modem) is defective.
Receiver is defective. (It may only be
transmitting CED)
Your machine's ID Number is not
programmed.
Possible incompatibility, or incorrect
Password (Password Reception,
Selective Receive).
Mailbox is full.
Receiver working in non-CCITT mode
only. (Possible incompatibility)
not set at the transmitter.
Document to be transmitted is not
placed at the transmitter.
Receiver is defective. (Modem, etc.)
FCB PCB is defective.
Receiver disconnects line during first
NSS (or DCS) is transmitted.
Line quality is poor. (TCF is damaged
due to line noise)
Receiver is defective. (Modem, etc.)
FCB PCB is defective.
XMT, RCV password does not match.
Last 4 digits of TSI does not match with
the last 4 digits of Auto Dial telephone
number.
351
DP-C405/C305/C265
Cause
FEB 2008