Information Code Table (For Facsimile) - Panasonic UF-9000 Service Manual

4.8.

Information Code Table (For Facsimile)

Code Mode
001 RCV
COPY
002 RCV
COPY
007 RCV
COPY
008
010 RCV
COPY
011 STANDBY
012 RCV
017
030 XMT
031 XMT
COPY
041 STANDBY
RCV
COPY
043 STANDBY
RCV
COPY
045 STANDBY
060 -
061 -
400 XMT
Ver. 3.0
Fax Information Codes
Phase Description of Problem
C, D Leading edge of the recording
paper fails to reach the Timing
Sensor. (1st Tray)
C, D Leading edge of the recording
paper fails to reach the Timing
Sensor. (2nd Tray)
C, D 1. Leading edge of the recording
paper fails to reach the Paper
Exit Sensor.
2. Recording paper has not
completely passed the Paper
Exit Sensor.
Paper Tray is opened while paper
is feeding.
B, C No recording paper.
B, C Paper Tray is not installed
properly.
C, D The length of the received
document is over 2 m.
Incorrect paper size loaded in the
Paper Tray.
B Read Point Sensor does not go
ON within 10 seconds after the
document starts feeding.
C Transmitting document was longer
than 2 meter (or 78.7 in).
B, C, D Out of Toner.
B, C, D Low Toner.
- No Toner Cartridge.
A Printer Cover is open.
A ADF Door is open.
B T1 timer (35 ± 5 sec.) elapsed
without detecting 300 bps signal.
Recording paper jam.
Timing Sensor abnormal.
Recording paper jam.
Timing Sensor abnormal.
Recording paper jam.
Paper Exit Sensor abnormal.
Paper Tray is opened.
No recording paper or paper is not set
properly.
No Paper Sensor is defective.
Connector is not installed properly.
Transmitter Document Jam.
Paper size is incorrect.
Document is not set properly.
Defective Read Point Sensor.
The document may jam.
Defective Read Point Sensor.
No toner.
Defective Low Toner Sensor.
Toner is getting low.
Defective Low Toner Sensor.
Toner Cartridge has not been installed.
Defective Toner Cartridge Sensor.
Cover is not firmly closed.
Connectors are not firmly connected.
Door is not firmly closed.
Connectors are not firmly connected.
Incorrect number was dialed and the
START button was pushed.
Telephone line was disconnected while
dialing.
SC PCB (Modem) or MJR PCB are
defective.
Receiver is defective. (It may only be
transmitting CED)
130
UF-9000
DP-180/190
Cause
APR 2006