Multicast Operation; Starting Multicast; Ending The Multicast; Handling Of Trouble During A Multicast - Panasonic KX-VC1300 User Manual

The multicast feature, compared to usage of an MCU, can reduce the network bandwidth used at the multicast
terminal's sites. When a transmission failure occurs during the multicast, the configuration of the terminals will
automatically change, so it is necessary that all terminals can connect and communicate with each other over
the network.
Note
•
In order to use the multicast feature, all HD Visual Communication Units that will comprise the multicast
system must have a Multicast activation key (KX-VCS302) installed.
•
The multicast feature will not operate when using IPv6 addresses.
•
To enable "Multicast" in "Enhancement", be sure to assign an IPv4 address to the unit in "Network
Settings". In cases where an IPv4 address is not assigned, such as when "IP Address (LAN
1)" (setting) is set to "Auto", but the status "Address is not assigned" is displayed, communication
using an IPv6 address cannot occur.
•
The multicast feature will not operate when using IP Mode (H.323).
•
The multicast feature will not operate when using NAT Traversal Mode.
•
The multicast data cannot be encrypted.
•
Connection using a SIP server cannot be performed.
•
When configuring a system of 32 or more units, a multicast server is required. For details, contact your
dealer.

Multicast Operation

Starting Multicast

In order to perform multicasting, multicast tree settings must first be set (Page 152, Page 153). When the
multicast is started from the multicast tree setting screen, connections are established with the lower level
terminals and then the multicast will begin (Page 157).
If a lower-level terminal's power is not on, or there is a network failure, and there is no response for the
connection confirmation, the configuration of the multicast tree will automatically change, and then the multicast
will begin. If a terminal that was removed from the configuration at startup responds with a connection
confirmation during the multicast, the multicast tree will automatically re-add the terminal and multicast data
to it.

Ending the Multicast

Press [END] at the multicast terminal to end the multicast.

Handling of Trouble During a Multicast

If a relay terminal loses its ability to connect to the multicast due to problems such as network trouble, the
multicast tree will automatically adjust and continue the multicast.
Document Version 2015-12
Using Multicast
User Manual 151