Preparation
LED Indication
LEDs indicate the operational status of the unit, as follows:
Power
LED
Off
Off
Off
Red on
Green
Blue flashing
flashing
Red
Off
flashing
Blue flashing
Green on
Blue on
Green on
Yellow on
Green on
Red on
Green on
Red flashing
Green on
Green on
Off
Screen Standby
When there is no video conference call transmission, and the remote control is not operated for more than 10
minutes (default), or when the remote control's [STANDBY] button is pressed, the unit enters screen standby
mode. Video out to the display is suspended and the status LED turns off.
Screen standby mode ends when the remote control is operated, or when a video conference call is received.
Notice
•
If screen standby mode ends and no image is visible, check to see if the display or video camera's
power saving settings are enabled. Check each device's manual for more information about its power
saving settings.
Note
•
You can change the length of time until the unit enters screen standby mode (Page 113).
•
The unit will not enter screen standby mode while displaying a computer's screen or a sub video
camera's image, even if the remote control is not operated for a period of time.
•
When the remote control is operated and screen standby mode ends, the Home screen will be
displayed.
•
If a button is pressed on the remote control to end screen standby mode, that button's operation is not
performed in that case.
•
If screen standby mode begins while editing information in the contact list or other screen, any unsaved
changes will be lost.
24
User Manual
Status LED
Status
•
AC power: OFF (Without power supplied
from the AC adapter)
•
AC power: ON (Power button: OFF)
•
Starting up
•
A hardware fault has occurred.
•
Startup state
•
Idle state
•
In a video conference call
•
Self diagnosis is being performed.
•
An error has occurred.
•
Maintenance is being performed.
•
Software update in progress
•
A serious error has occurred.
•
In screen standby mode
Document Version 2015-12