Panasonic KX-VC1300 User Manual page 32

Preparation
•
For computers without HDMI ports, connect the
computer to the RGB terminal on the back of the
unit using a VGA cable.
Note
•
You can connect/disconnect the computer
during a video conference call.
•
One of the following resolutions is required
for transmitting computer images: VGA
(640 ´ 480), SVGA (800 ´ 600), XGA
(1024 ´ 768), HD (1280 ´ 720), WXGA
(1280 ´ 768, 1280 ´ 800), SXGA
(1280 ´ 1024), FWXGA (1360 ´ 768,
1366 ´ 768), WXGA+ (1440 ´ 900), WXGA
++ (1600 ´ 900), UXGA (1600 ´ 1200),
WSXGA + (1680 ´ 1050), Full-HD
(1920 ´ 1080).
•
If both HDMI and VGA cables are
connected to the unit, the image of the
computer connected using an HDMI cable
will be displayed.
32 User Manual
Amplifier/Active Speaker
Connection
This section describes how to connect an amplifier/
active speaker.
1.
Connect the amplifier/active speaker to the Audio
Out L/R jack on the back of the unit using a stereo
pin plug cable.
Note
•
Connect the amplifier/active speaker
correctly, as follows:
– Left channel ® L
– Right channel ® R
•
For more details about the amplifier or
active speaker, refer to the documentation
for the corresponding device.
Layout example:
Place the speakers either side of the display, as follows:
Microphone
Notice
•
Place the speakers either side of the display. If
you place the display at the front of the room
and the speakers at the back, the microphone's
left/right spatial direction may be reversed, and
the orientation of the image and sound will not
match on the other party's side.
Speaker
Display
Main
video
camera
Speaker
Document Version 2015-12